Jump to content

Featured Replies

Posted

I was amused at this photo that Rob took for some reason and would like to see some captions put to the photo.

 

20061019_151_coolspring.jpg

I was amused at this photo that Rob too for some reason and would like to see some captions put to the photo.

 

"...and this lever allows the author to clean up sloppy syntax."

oh alright i'll go there: "so whattaya say we get to greasin these things?"

 

    "Your horsepower capacity will be limited by your beam strength or the surface strength of your gear teeth. If your single-reduction, splash lubricated units get too hot, you need more surface area to dissipate the excess heat....."

 

  (3 hours later)

 

    "In the old pulverized coal fired furnaces like they used to use, the tubes were extended about the furnace floor to form a slag screen to cool the ash and protect the bottom.  That was before they made the slag screen of stud tubes across the upper part of the furnace below the boiler tubes. Those things were a pain to clean out. But if you used bituminous coal..."

 

"Don't turn around, another idiot is taking a picture."

 

 

 

 

 

 

:wink:

"How do you think I would look in a tutu?"

"Are you Mr. Doucheman?"

"Did you catch Project Runway last night?"

 

    "Your horsepower capacity will be limited by your beam strength or the surface strength of your gear teeth. If your single-reduction, splash lubricated units get too hot, you need more surface area to dissipate the excess heat....."

 

   (3 hours later)

 

    "In the old pulverized coal fired furnaces like they used to use, the tubes were extended about the furnace floor to form a slag screen to cool the ash and protect the bottom.  That was before they made the slag screen of stud tubes across the upper part of the furnace below the boiler tubes. Those things were a pain to clean out. But if you used bituminous coal..."

 

 

Hah! The cat is out of the bag! You've been hanging out at these places, too.  :-D

 

 

"Don't turn around, another idiot is taking a picture."

 

 

That, too.  :laugh:

What would you prefer?  Gears or benches.

I've been holding this pipe in place for 3 hours. Can you take over while I go to lunch?

"Now that we've gotten our hands on all these here cannons....what the sam hill should we do with 'em??"

"I'm a little teapot short and stout, here is my handle, here is my spout"

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.